University of Hertfordshire

From the same journal

By the same authors

Documents

View graph of relations
Original languageEnglish
JournalIEEE Transactions on Circuits and Systems I: Regular Papers
Early online date25 Aug 2021
DOIs
Publication statusE-pub ahead of print - 25 Aug 2021

Abstract

The millimeter-wave (mm-wave) single-pole double-throw (SPDT) switch designed in bulk CMOS technology has limited power-handling capability in terms of 1-dB compression point (P1dB) inherently. This is mainly due to the low threshold voltage of the switching transistors used for shunt-connected configuration. To solve this issue, an innovative approach is presented in this work, which utilizes a unique passive ring structure. It allows a relatively strong RF signal passing through the TX branch, while the switching transistors are turned on. Thus, the fundamental limitation for P1dB due to reduced threshold voltage is overcome. To prove the presented approach is feasible in practice, a 90-GHz asymmetrical SPDT switch is designed in a standard 55-nm bulk CMOS technology. The design has achieved an insertion loss of 3.2 dB and 3.6 dB in TX and RX mode, respectively. Moreover, more than 20 dB isolation is obtained in both modes. Because of using the proposed passive ring structure, a remarkable P1dB is achieved. No gain compression is observed at all, while a 19.5 dBm input power is injected into the TX branch of the designed SPDT switch. The die area of this design is only 0.26 mm2.

Notes

© Copyright 2021 IEEE. This is the accepted manuscript version of an article which has been published in final form at https://doi.org/10.1109/TCSI.2021.3106231

ID: 25777100