University of Hertfordshire

By the same authors

View graph of relations
Original languageEnglish
Pages (from-to)2043-2052
JournalEngineering Science and Technology, An International Journal
Volume19
Issue4
Early online date21 Aug 2016
DOIs
Publication statusPublished - 1 Dec 2016

Abstract

The conventional homogeneous materials can no longer effectively satisfy the growing demands on product capabilities and performance, due to the advancement in products design and materials engineering. Therefore, the fibre reinforced composites (FRCs) with better properties and desirable applications
emerged. These enhanced qualities of the FRCs have emphasized the need for analysing their machinability for further improvement of performance. Hence, this paper presents a comprehensive investigation on the machinability effects of drilling parameters (feed rate, cutting speed and thrust force), drill diameters
and chips formation mainly on delamination and surface roughness of hemp fibre reinforced polymer (19/HFRP) and carbon fibre reinforced polymer (MTM 44-1/CFRP) composite laminates, using high speed steel (HSS) drills under dry machining condition. The results obtained depict that an increase in feed rate
and thrust force caused an increase in delamination and surface roughness of both samples, different from cutting speed. Also, increased drill diameter and types of chips formation caused an increase in both delamination and surface roughness of both samples, as the material removal rate (MRR) increased.
Evidently, the minimum surface roughness and delamination factor of the two samples for an optimal drilling are associated with feed rates of 0.05–0.10 mm/rev and cutting speed of 30 m/min.

Notes

© 2016 Karabuk University. Publishing services by Elsevier B.V. This is an open access article under the CC-BY-NC-ND license.

ID: 15446614