University of Hertfordshire

Influence of Drill Geometry Design on Drilling-Induced Damage Reduction in Fibre-Reinforced Polymeric Composites

Research output: Chapter in Book/Report/Conference proceedingChapter (peer-reviewed)peer-review

View graph of relations
Original languageEnglish
Title of host publicationMachining and Machinability of Fibre Reinforced Polymer Composites
EditorsM. T. H. Sultan, A. I. Azmi, M. S. B. A. Majid, M. Jamir, N. Saba
Place of PublicationSingapore
PublisherSpringer Singapore
Chapter2
Edition1st
ISBN (Electronic)9789813341531
ISBN (Print)9789813341524
DOIs
Publication statusPublished - 18 Feb 2021

Abstract

Drilling is an extensively used manufacturing process for boring different and widely used fibre-reinforced polymeric (FRP) composite materials, among various machining operations. This process is inevitable for assembling/coupling of parts of systems. Despite of the good inherent properties of the FRP composite materials, they are not easy to drill, due to the dissimilar properties of their constituents (mainly fibre/reinforcement and matrix). More than a few drilling-induced damage (DID) on FRP composites include delamination, surface roughness, fibre-pull out/uncut, among others. They severely affect the quality, structural integrity and applications of the drilled composite components. The most rampant among these damage is delamination; either peel-up or push-out type. Importantly, these damage are frequent and attributed mainly to the geometry design of the drill bits used. It is highly germane to consider and further study the influence of the drill geometry design (DGD) on reduction of DID on FRP composite components and improve the quality of the drilled holes. Therefore, this present chapter focuses on a current status/trend in the drilling of FRP composites and comprehensively reports optimum drill geometry designs (DGDs) for different FRP composites. It was evident that a combination of an efficient drill geometry (chisel and cutting edges, helix and point angles, diameter, length, material, among others) design and suitable selected drilling process parameters (cutting speed, feed rate, depth-of-cut, material removal
rate, among others) produced minimum DID on FRP composite components. This
knowledge is required to guide drill designers, manufacturers, machinists and
researchers in their search for high performance drilling phenomenon.

Notes

© 2021 Springer-Verlag. The final publication is available at Springer via https;//dx.doi.org/10.1007/978-981-33-4153-1.

ID: 24114958